Project
- Stars
- Started
- Issues
- License
Mitsubishi CN105 HomeKit Controller
FirmwareControl the heat pump from Apple Home without a hub
This firmware connects a supported ESP32 board to CN105 and exposes the heat pump directly to Apple Home on your network. It also provides an on-device web interface and can use compatible Bluetooth thermometers as the room-temperature source.
Prebuilt and hardware-tested profiles cover M5Stack NanoC6 and Atom S3 Lite boards. Other ESP32 profiles require a source build and are unverified, while available modes, vanes and temperature readings depend on the indoor unit. Installing it means opening the indoor unit and wiring a small board to its CN105 port.
- Control your heat pump without the cloud
- Use your heat pump in your smart home
- Heat or cool the room where you sit
- On-device web controls
- Bluetooth room-thermometer selection and averaging
- Direct HomeKit accessory
Project
- Stars
- Started
- Issues
- License
Built by
Works on
Similar mods
Feedback
How did it go? Tips, problems, questions…
Feedback
How did it go? Tips, problems, questions…