Project
- Stars
- Started
- Issues
- License
Klipper for Ender-3 V3 SE with display
FirmwareKlipper on the V3 SE with its stock screen working
This is a modified Klipper for the Ender-3 V3 SE that drives the printer's original screen over a serial bridge, through the printer's own display cable and with no hardware changes. The screen can start, pause and stop prints, move and home axes, set temperatures and the Z offset, run a manual-probe popup and call your own macros from a Misc menu.
You flash a prebuilt .bin from the repo's releases from an SD card, or build it with make menuconfig, then add an [e3v3se_display] section to printer.cfg. It is based on display firmware 1.0.6, so a newer Creality display version can break it. Max speed, max acceleration and steps per mm are not available on the screen.
- Run firmware you can change
- Get a fuller on-printer screen
- Custom macro menu on the stock screen
- Prebuilt firmware binaries for the SE
Feedback
How did it go? Tips, problems, questions…
Feedback
How did it go? Tips, problems, questions…