Project
- Stars
- Started
- Issues
- License
KICKR Dongle Virtual Shifting
FirmwareAdd Zwift virtual shifting to a legacy KICKR
KICKR Dongle Virtual Shifting runs on a LilyGo T-Dongle-S3 between Zwift and an older KICKR trainer. It translates virtual shifts into the trainer’s legacy resistance commands and shows connection status on the dongle. You need to build the firmware with Arduino, use a Zwift Click and have access to Zwift, normally through a paid membership.
Compatibility depends on firmware that still responds to Wahoo’s legacy CPS simulation commands. The documented candidates are KICKR generations 1 and 2 and early SNAP models; modern FTMS/ZVS firmware may ignore the commands.
- Shift virtually on your indoor trainer
- Zwift virtual shifting bridge
- Dongle connection display
Project
- Stars
- Started
- Issues
- License
Built by
Works on
Wahoo KICKR trainers and ELEMNT bike computers
Similar mods
Feedback
How did it go? Tips, problems, questions…
Feedback
How did it go? Tips, problems, questions…